Columbia Coronado 25 Owenrs Manual page 113

6.4 (continued)
9. Remove the masking tape; and, as soon as the
gel coat has cured, block-sand it with 400 grit
sandpaper and water to remove orange peel and any
lap lines that may have developed. Hand-sand if
necessary to smooth stubborn areas.
5. Wet-sand with 600 grit sandpaper.
6. To restore gloss, buff with harsh grit buffing compound and
heavy duty polisher.
6.4.1 Finishing Large Areas with Epoxy Enamel
when a large area needs to be refinished, it is recommended that the
entire section be done with a good quality epoxy enamel.
Manufacturers of epoxy enamels supply application instructions on the labels
of the cans and in published booklets. The manufacturer's instructions should
be followed since different types require different solvents and/or handling.
The following is a typical epoxy enamel finishing system which can be used as
a guide.
TOOLS
Suction spray gun or
Paint brushes (good
quality bristle)
White cloth
100, 400, 600 grit wet
or dry sandpaper
Masking tape
Sanding block
Paper
Stirring sticks
H. Preparing the Surface
1. Prepare the surface as instructed in Section
6.2.
SECTION 6
Page 33
MATERIAL
Sanding surfacer - if
required by enamel
manufacturer
Epoxy enamel of desired color
Thinner - as specified by
manufacturer