Table of Contents
Advertisement
5.5
(continued)
2.
Remove the balsacore (Item 6) and inner hull laminate for an area
around the thru-hull, large enough in diameter to allow the plywood
donut to seat properly.
3.
With the thru-hull temporarily located, fill the void around it with
random matting and resin (Item 5) as shown.
4.
Bond over this, filling with a cover bond (Item 1) according to
Section 5A of CSP-00-9031. (1 lam 24 oz. roving and 3 oz. mat).
5.
Finish the installation by sealing the thru-hull and tightening
nut (Item 3).
6.
If the thru-hull device is of a flush mounting type use a bond equal
to the outer hull laminate to secure it in place prior to filling
the void, as defined in Step 3.
SECTION 5
Page 10
Hide quick links:
Advertisement
Table of Contents
