Advertisement
Your BitHead has been supplied with a number of different feet. The rubber feet can be stuck
to the bottom of the amp if you are simply going to place it on a tabletop. But we like to attach
the amp to the various source devices with the enclosed Velcoins. First, remove the hook coins
(the scratchy ones with all the miniature hooks) from their adhesive strip and stick them into
the three circular foot wells on the bottom of the amp.
Then, clean the surface where you want to mount your BitHead. On portable players we recom-
mend mounting the amp to the bottom side of your portable player with the amp controls facing
towards you. In this configuration the rubber door will act as a non-slip foot and the players'
controls will tilt slightly towards you for easy access. When used with laptop computers, we
recommend sticking the amp on the back of the display with the amp controls about even with
the right or left hand side of the display so they can be easily reached. With home computers
you can attach the amp to the tower or to the bottom of your desk for easy fingertip access.
Then, remove the loop coins from the strip, and stick them to the hook coin in the feet of the
BitHead, adhesive side out. Carefully position the BitHead just above the desired spot, then
slowly and firmly push the BitHead against the surface. This should stick the loop Velcoins
into proper position. Carefully remove the BitHead leaving the loop coins, and then press
each more firmly into place by hand.
Additional Velcoins are available for purchase through our website.
BitHead & Velcoins
BitHead & player
attached
How to Mount Your BitHead Amp
attaching the Velcoins
BitHead attached
to desk
player with Velcoins
BitHead attached
to laptop
5
Advertisement
