Summary of Contents for HeadRoom Headphone Amplifier & Digital-Analog Converter
Page 1
Congratulations! You’ve just received the cutest little piece of hard-core audio hardware known to the world of audiophilia. The Micro Amp and Micro DAC are jam packed with all the sweet parts, terrific engineering, quality manufacturing, and years of experience needed to make luscious tunes bloom in your head.
Page 2
The HeadRoom crossfeed provides the natural acoustic cross-feed normally heard at the left and right ear as heard from the left and right speaker.
Page 3
The Micro DAC The unlikely marriage of a well supported Texas Instruments USB sound de- vice chip (to get the S/PDIF signal), Cirrus Logic’s flagship D/A converter, and two 9-Volt batteries bears the fruit of incredibly good sound anywhere you want to set up a personal listening station.
1/8 jack on the front of the Micro Amp. Adjust the volume on the HeadRoom amp. The Micro Amp and DAC run on DC power or two 9 volt batteries. The battery life of your Micro Amp will last approximately 15-20 hours, depending on the impedance level of the headphones you are using, as well as the electronics module you have (The DAC will not last quite as long).
Page 5
HeadRoom amplifiers cure the problem by allowing you to cross-feed a little of the left and right channels across to each other through a short time de- lay using the crossfeed switch.
Page 6
HeadRoom products. If the cost of the repair is over $100, we will call you with an estimate. If you have an older HeadRoom amp that is out of production, we may not be able to repair the amp, however please contact us and we will let you know if we are able to.
Page 7
As a result, even though the volume control on your HeadRoom amp may appear to be set to a low level, you may not be listening at a safe level. Generally speaking, when listening to headphones you should only turn up the volume to the point at which the sound isn’t too quiet.
Need help?
Do you have a question about the Headphone Amplifier & Digital-Analog Converter and is the answer not in the manual?
Questions and answers