Dimensional Drawings - Daikin FWF-BT Technical Data Manual

Fan coil units 4-way blow ceiling mounted cassette

Hide thumbs

Table of Contents

Dimensional drawings

7 - 1 Dimensional Drawings

FWF-BT/BF

VIEW A

Suspension bolt

NOTES

1. Sticking location for manufacturer's label: For indoor unit: on the bell mouth inside suction grille. For decoration panel: on the inner frame inside suction grille.

2. In case of using Infrared remote control, this position will be a signal receiver. Refer to drawing of Infrared remote control for details.

3. When the temperature and humidity in the ceiling exceeds 30°C and RH 80% or the fresh air is inducted into the ceiling or the unit continues 24 hours operation,

an additional insulation is required. (Thickness 10mm or more of glaswool or PE foam)

4. Though the installation is acceptable up to maximum of 660 mm square ceiling opening, keep a clearance of 45 mm or less between the main unit and the ceiling opening,

so that the panel overlap can be ensured.

• Indoor Unit • 4-way blow ceiling mounted cassette • FWF-BF

585-660 (Ceiling opening space)

300 or less

Note2

Drain connection side

Pipe connection side

45 or less

• Fan coil • Indoor Unit

533 (Suspension position)

REQUIRED SPACE

(a) When the discharge grille is covered (by an option kit) the required space is 200mm or more