Field & Wiring Harness; Clutch Housing - Graco GM3000 Instructions-Parts List Manual

NOTE: Refer to Fig. 18.
1. Back out the four setscrews (58) holding the field
(53) to the clutch housing (1) approximately 3
turns.
2. Pull out the field. The field fits closely to the clutch
housing and must be removed carefully to prevent
jamming.
3. Pull the plastic caps (B) off the wire screws (79) in
both places on the field. Remove the screws and
remove the wire (A).
4. Skip ahead to Reassembly, page 28, Step 4 or
continue on page 27.
NOTE: A standard steering wheel puller and two
1/4–28 x 3 or 4 in. long screws are required to remove
the clamp.
NOTE: Refer to Fig. 19.
1. Loosen the two screws (57) on the clamp (55),
working through the slot at the bottom of the clutch
housing (1).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp (55). Tighten the
screw (C) until the clamp comes off.
3. Skip ahead to Reassembly, page 28, Step 2, or
continue below.
NOTE: Refer to Fig. 20.
CAUTION
If the clutch housing is removed from the engine a
special alignment tool is required to reinstall it.
1. Remove the four capscrews (83) and lockwashers
(84) which hold the clutch housing (1) to the en-
gine.
2. Remove the engine key (56).
3. Pull off the clutch housing (1).
4. Skip ahead to Reassembly, page 28, Step 1.
Field & Wiring Harness
Clamp

Clutch Housing

1
53
79
Fig. 18
1
A
B
C
Fig. 19
56
1
84
83
Fig. 20
58
A
B
05839
55
57
05840
05841A
308620 27