Engine - Graco GM3000 Instructions-Parts List Manual

NOTE: The engine must be removed before the
Clamp and Clutch Housing can be removed.
CAUTION
The sprayer will be out of balance when the engine,
clutch housing, drive housing and pinion housing are
removed. Support the rear of the cart to prevent the
partially disassembled sprayer from falling over.
CAUTION
The sprayer will experience poor clutch life if a
replacement engine is purchased from another
vendor. The engine for this sprayer is manufactured
by Honda to a special Graco specification.
1. Working under the mounting plate (A), remove the
two lock nuts (78) and then pull the screws (77)
out of the base of the engine. Remove the screw
(61). Disconnect the red wire (B) from the engine
lead (D). Disconnect the black and white wires
from the field. Pull the cable (E) carefully through
the grommet (50) before removing the engine. See
Fig. 16 and 17.
2. Lift the engine carefully and place it on a work
bench.
3. Remove the Field and Wiring Harness, Clamp
and Clutch Housing, as instructed on page 27.
NOTE: All service to the engine must be performed by
an authorized Honda dealer.
1
To engine alternator.
E
78, 87
86
50
Bottom View of Engine and Cart
Fig. 16
26 308620

Engine

50
WHITE
BLACK
1
B
RED
D
06006A
1
D
50
61
A
Fig. 17
77
78
06903