Displacement Pump Repair
WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 12.
NOTE: Packing Repair Kit 235703 is available. Refer-
ence numbers of parts included in the kit are marked
with an asterisk, i.e., (121*). For the best results, use
all the new parts in the kit, even if the old ones still look
good.
NOTE: To minimize down time, and for the best sprayer
performance, clean the transducer (see page 20) when-
ever you repack the pump. Replace these parts as need-
ed.
9
Fig. 24
Removing the pump
1. Flush the pump, if possible. Relieve pressure. Stop
2. Remove the filter (21).
3. Remove suction hose or tube (40).(For suction
NOTE: If repairing only the intake valve assembly, go
to Intake valve repair, in manual 308190.
4. Use a screwdriver to push the retaining spring (12)
5. Loosen the screws (17). Remove the pump (18).
12
21
107
1
17
40
2
39
(See Fig. 24.)
the pump with the piston rod (107) in its lowest
position, if possible.
hose, refer to page 21.
up and push out the pin (11).
120
11
*122
18
*121
*119
30
118
Torque to
1
50 ft–lb (68 N.m)
2
Apply sealant
Model 231363 Shown
05844
308620
31