Desa (V)GM36 Installation Instructions Manual page 27

Spring clips have been installed but some adjustments may be needed. Install the doors using the following steps.
•
With bi-fold doors completely folded, insert bottom pivot pin into pivot hole located near bottom corner of front face opening
and swing door to vertical position making sure top pins slide into door track. Door is installed when top door pin snaps into
spring clip.
•
Repeat step for remaining door.
If you find the doors do not close properly or do not appear level or straight, proceed with section on door adjustment.
Remove doors and slightly loosen lower pivot clips and upper spring clips. Replace doors and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting is achieved, carefully open doors enough so that you can access spring clips with a
Phillips screwdriver. Tighten screws as shown.
INSTALLING GLASS DOORS
DOOR ADJUSTMENT
- -
25
For more information, visit www.desatech.com