Scanning Barcodes - Panasonic Barcode Scanners Using Instruction

Table of Contents

Advertisement

Scanning Barcodes

1
Aim the scanner at the barcode.
2
Press one of the trigger buttons on either side
of the computer.
If the barcode scan application software has been set for use
with F1, F2, F3, or option buttons (using [Start]-[Settings]-
[Control Panel]-[Barcode Scanner]-[Button]), press the but-
ton assigned for this function (
the Handheld Computer Operating Instructions).
The red scan beam for reading is emitted from the scanning
window. Make sure the red scan beam covers the entire barcode.
NOTE
It is impossible to scan a barcode for 5 or 6 seconds after turning on the computer
because the barcode scanner is being initialized.
To Correctly Read a Barcode with This Computer, Observe the Following.
The scanning angle is a very important factor. The scanner may be unable to correctly
read a barcode if it is directly perpendicular to the barcode and the red scan beam is
reflected back into the scanner. Perform reading at the angle indicated in the figure. Set at
a 15° angle from the perpendicular position.
Perform scanning so that the red scan beam for reading intersects the barcode itself (in-
cluding at least 12.7 mm {1/2"} beyond each edge of the barcode).
Hold the scanner farther away when reading a larger barcode, and closer in when reading
a smaller barcode or a thinner barcode.
"Program Buttons" in
Right
Right
Press trigger button.
Wrong
Wrong
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents