Removing The Riser Board Shipping Bracket; Installing An Expansion Board - Compaq Proliant ML370 User Manual

4-12 Compaq ProLiant ML370 Setup and Installation Guide
Removing the Riser Board Shipping
Bracket

Installing an Expansion Board

Some ProLiant ML370 servers are packaged with a shipping bracket for
greater stability in the area of the riser board. Before installing an expansion
board, remove the shipping bracket:
1. If your server contains a riser board shipping bracket, press in on the
tab on the back of the shipping bracket to release it, as shown in the


illustration below.
2. Slide the bracket toward the system board and lift out, away from the
assembly .

1
2
Figure 4-10. Removing the riser board shipping bracket
NOTE: The shipping bracket may not be included on all servers.
To install an expansion board, such as a drive array controller or video board,
refer to one of the following installation sources:
For a text and illustration procedure, refer to the installation


documentation that came with the option kit.
For a text overview of the procedure, refer to the procedure below.