Audio Equipment; Listening To The Sound Of Other Audio Equipment - JVC SP-EXA10 Instructions Manual

Listening to the sound of other audio equipment

MEMORY
Connect the other audio equipment to this system
in advance (A page 12).
1
Slide the remote control
mode selector to
RECEIVER.
2
Press AUX to select
"AUX-DIGITAL" or "AUX".
• Each time you press AUX, the display on
the receiver toggles between
"AUX-DIGITAL" and "AUX".
• The source changes to the signal from the
AUX terminals.
• You can also use SOURCE SELECT on the
receiver to select the signal from the AUX
terminals as the sound source.
3
Begin playback on the other

audio equipment.

• For details on beginning playback, refer to
the manual of the connected equipment.
4
Adjust the volume and the
sound quality of the system
(A page 16).
NOTE
• When no equipment is connected to the DIGITAL IN
AUX terminal or the power of the connected
equipment is off, after "AUX-DIGITAL" is selected,
the display changes to "AUX-D UNLOCK".
41
Adjust the sound input level of the audio
equipment
Remote control
You can adjust the sound input level of audio
mode selector
equipment connected to the AUX terminals.
1
AUX
2
(play)
3
3
Listening to the sound of other audio equipment
Slide the remote control
mode selector to
RECEIVER.
Press AUX to select "AUX".
• Each time you press AUX, the display on
the receiver toggles between
"AUX-DIGITAL" and "AUX".
• The source changes to the signal from the
AUX terminals.
Hold down MEMORY until the
input level is displayed.
• Each time you hold down the button, the
input level switches as follows:
LEVEL1 STORED: For normal use.
(initial setting)
LEVEL2 STORED: To correct distorted
sound caused by an
extremely high input
level from other
equipment.