Removing Front Wheels; Removing Rear Wheels - Britax MOTION 3 Instructions Manual

Infant Car Seat Mode Asse
Attaching BOB Unity
Infant Car Seat
1. Lock the parking brake. Fully recline the
backrest and fold the canopy back.
Position the Infant Car Seat over the stroller
with feet end facing the stroller backrest.
With the Infant Car Seat handle in the
upright position align the adaptors on the
Car Seat with the receivers on the stroller.
2. Lower the Infant Car Seat into the receivers.
The Infant Car Seat now needs to be locked
securely into the receivers. Squeeze in and
hold the latches on either side of the handle
and rotate the handle backwards.
20
Removing Front Wheel
1. Push the metal tab above the swivel lock in
to release the wheel and pull wheel away
from the stroller.

Removing Rear Wheels

1.
Pull and hold the release lever on the rear
axle bottom while pulling the rear wheel
away from the stroller.
NOTE: Pneumatic front and rear tyres can be inflated with the pump
(where supplied) or a bicycle pump or at a garage pump.
Maximum inflation pressure front tyre: 2.1 bar (30 p.s.i).
Maximum inflation pressure rear tyre: 2.1 bar (30 p.s.i).
1. Slide the canopy stay brackets into the
canopy mounts of the stroller frame until
they lock into place.
Assembly
9