Britax MOTION 3 Instructions Manual page 13

Securing Your Child
Seat Harness
(Continued)
2. Fasten the harness by inserting the buckle
tongues into the buckle assembly. Each
buckle tongue has a raised rib on one side
and can only be locked into the buckle
assembly with the raised rib facing up.
Note: Ensure the straps are not twisted
as they may become uncomfortable for
the child.
IMPORTANT: Pull on each buckle tongue
to make sure the are locked into the
crotch buckle assembly. If not, repeat
above procedure.
3. IMPORTANT: The top section of the
shoulder harness strap should be
adjusted to fit just above the child's
shoulder height.
Open hook and loop straps. Slide the 3 bar
harness adjuster up or down to adjust to the
desired shoulder height then fasten hook
and loop strips below the harness adjuster
to keep the adjusters in place.
IMPORTANT:
ABOVE THE HOOK AND LOOP STRAPS.
16
Raised Rib
HARNESS ADJUSTERS MUST SIT
Canopy
3. For additional air circulation, the back flap
of the canopy can be rolled up and
secured with the toggle and elastic.
Pivotal Handle
1. To adjust the handle height, squeeze in
and hold the buttons on the inside of the
handle. Rotate the handle up and down to
the desired position. When the desired
position has been achieved, release the
buttons.
Operating Instructions
13