A Basic Traffic Shaping Scenario - D-Link DFL-1660 User Manual

10.1.10. More Pipe Examples
The reason for using 2 different pipes in this case, is that these are easier to match to the physical
link capacity. This is especially true with asynchronous links such as ADSL.
First, two pipes called in-pipe and out-pipe need to be created with the following parameters:
Pipe Name
in-pipe
out-pipe
Dynamic Balancing should be enabled for both pipes. Instead of PerDestIP and PerSrcIP we could
have used PerDestNet and PerSrcNet if there were several networks on the inside.
The next step is to create the following Pipe Rule which will force traffic to flow through the pipes.
Rule
Name
all_1mbps
The rule will force all traffic to the default precedence level and the pipes will limit total traffic to
their 1 Mbps limit. Having Dynamic Balancing enabled on the pipes means that all users will be
allocated a fair share of this capacity.
Using Several Precedences
We now extend the above example by allocating priorities to different kinds of traffic accessing the
Internet from a headquarters office.
Lets assume we have a symmetric 2/2 Mbps link to the Internet. We will allocate descending
priorities and traffic requirements to the following users:
• Priority 6 - VoIP (500 kpbs)
Figure 10.7. A Basic Traffic Shaping Scenario
Min Prec Def Prec
0 0
0 0
Forward Return
Pipes Pipes
out-pipe in-pipe
Max Prec Grouping
7 PerDestIP
7 PerSrcIP
Source Source Destination
Interface Network
lan lannet
508
Chapter 10. Traffic Management
Net size Pipe limit
24
24
Destination
Interface Network
wan all-nets
1000kb
1000kb
Selected
Service
all