D-Link DFL-1660 User Manual page 577

Database Console Commands
An Anti-Virus update can similarly be initiated with the command:
gw-world:/> updatecenter -update Antivirus
Querying Update Status
To get the status of IDP updates use the command:
gw-world:/> updatecenter -status IDP
To get the status of AV updates:
gw-world:/> updatecenter -status Antivirus
Querying Server Status
To get the status of the D-Link network servers use the command:
gw-world:/> updatecenter -servers
Deleting Local Databases
Some technical problem in the operation of either IDP or the Anti-Virus modules may be resolved
by deleting the database and reloading. For IDP this is done with the command:
gw-world:/> removedb IDP
To remove the Anti-Virus database, use the command:
gw-world:/> removedb Antivirus
Once removed, the entire system should be rebooted and a database update initiated. Removing the
database is also recommended if either IDP or Anti-Virus is not used for longer periods of time.
Note: Updating the database causes a pause in processing
Anti-Virus database updates require a couple of seconds to be optimized once an
update is downloaded. This will cause the firewall to momentarily pause in its
operation. It can therefore be best to set the timing of updates to be at times of low
traffic, such as in the early hours of the morning. Deleting a database can cause a
similar pause in operation.
Appendix A. Subscribing to Updates
577