Too Much Noise In Washing; The Tub Rotates To One Direction(In Washing) - Haier HLP24E Service Manual

Service Manual
Order No. TL1001S003V1.1
6-2-8

Too much noise in washing

If the noise of the motor
is too much?
If the motor fastened tightly?
The pulsator is rubbing the
bottom of the inner tub
6-2-9. The tub rotates to one direction (in washing)
Y
Adjust the paw spring
Adjust the
Y
connecting arm of
the paw
Y
Adjust the retracting
spring
Adjust the
Y
adjusting screw of
the brake lever
Yes
No
No
Yes
Start the no-water test
program;do no-water washing
Check if the drain motor works
Y
Check if the paw
spring is unlocked
N
Check if
the two paws are
inserted into the two ratchet
simultaneously
N
Check if the
retracting spring of the
l oose
retarder is
N
Check if
the gap between
the adjusting screw of the
retarder brake lever and the baffle
plate of the paw connecting
arm is too small
N
Replace the retarder
Replace the motor.
Fasten the motor.
Add pulsator gasket.
Check
if the
purple,blue and yellow
N
legwire of HMwire are inlayed to
the corresponding 1,2,3
terminals of the drain
motor
Y
Measure
the voltage between the 1,2
terminals of the drain
motor
Not exist
Measure
the voltage between
the purple and blue terminals of
the computer
sequencer
Not exist
Replace the computer sequencer
At this time please confirm if the drain motor works normally
20
Issue
Rev.
N
Inlay the HMwire again
Exist
Replace drain motor
Exist
Replace the wire unit