Britax B-SAFE User Manual page 17

• Place the base in the desired
location on the seat and press
the LATCH connectors onto
the adjacent vehicle anchors
until a click is heard.
NOTE: Pull the LATCH connector to
verify that it is secure.
• While pressing the base
down into the seat, pull up on
the LATCH adjuster strap to
tighten.
• Open the two portions of the
lock-off and route the excess
LATCH strap webbing through.
• Close the top portion and then
the bottom portion of the lock-
off to secure excess webbing.
NOTE: Excess webbing can interfere
with the infant car seat connecting
correctly with the base. Excess webbing
should always be stored.
• Verify that the LATCH strap is tight and that the base is secure.
The base is secure when it moves less than 1 inch (2.5 cm)
front-to-back or side-to-side at the vehicle belt path.
• Correct recline angle is acheived when the green marker on
each recline angle indicator is visible between the two lines.
Installing the Base
15