Clifford 50.7X Installation Manual page 51

Security and remote start
Table of Contents

Advertisement

"times out" when the remote start activates in timer mode. The system may be
shut down using a shutdown at any time. Using the Bitwriter®, the run time can
be programmed for any duration from 1-16 minutes.
3-8 Flex Relay Function: Ignition 2 (1)
In the factory setting, the flex relay func-
tions the same as the pink ignition 1 wire, in accessory (2) setting the flex relay
functions the same as the Orange accessory 1 wire, in starter (3) setting the flex
relay functions the same as the purple starter 1 wire.
3-9 Diesel Timer—Wait-To-Start Input (1)
- 15 (2), 30 (3), or 45 (4) seconds.
Default is the "Wait-to-Start" input control wire, or programmable to ignore
the input control wire by a delay of 15 ,30, or 45 seconds. This feature can
also be optionally programmed with the Bitwriter®, with a delay from 1 to 90
seconds in one second increments.
3-10 Accessory State During Wait-To-Start: On (1)
OFF (2): This feature allows
the selection of the accessory output to be ON or OFF during wait-to-start. Use
the two-chirp setting for OFF.
3-11 2nd Status Output: Normal (1)
Latched (2) Pulsed (3): This feature allows
selection of status output or a rear defogger mode that turns on ten seconds after
the vehicle has started if the vehicle interior temperature is below 55 degrees F.
The defogger mode has two selections, latched, or pulsed. Latched mode only
stays on for 10 minutes.
Note:
When the defogger mode is on, the output is always active and can
be turned on independently with the remote for a one-time activation. (See the
Remote Functions table.)
3-12 Parking Lights: Constant (1)
:
Flashing (2) OFF (3)
In the default setting, the
parking lights (if connected) comes on solid during the remote start runtime. In
the two- flash setting the parking lights flashes during the remote start runtime. In
the OFF setting, the parking lights do not come ON or flash, when the vehicle
is remote started.
3-13 Anti-Grind: On (1)
:
OFF (2)
With the anti-grind On (default) the ground-
when-armed output is active during remote start operation. This activates the
starter kill relay and prevents the customer from re-cranking the car with the key,
when doing key takeover. If accessories such as a voice module or window
51
© 2008 Directed Electronics. All rights reserved.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Responder lc 50.7x

Table of Contents