Menu 2 - Convenience - Clifford 50.7X Installation Manual

➢ Menu 2 - Convenience

2-1 One time bypass Off (1):
One time bypass ON. When programmed On
(2) the unit does not passively arm/lock for one cycle when turning the ignition
On and Off within 3 seconds. When going through this procedure the siren
chirps once indicating that One Time Bypass has been activated.
2-2 Nuisance Prevention® Circuitry (NPC) On (1): Nuisance Prevention Circu-
ity OFF (2). NPC stops repeated triggering of the same zone. If one zone is
triggered three times in one hour, that zone is bypassed for one hour, starting
from the time of the third trigger. During that hour, if the system sees a trigger on
that zone again, the system resets the one hour timer.
If one hour passes and the zone has not triggered again, the zone is activated
and can trigger the system again. NPC only monitors sensor inputs, and does
not bypass the door trigger or the ignition trigger at any time.
If NPC is turned off, the system responds to repeated triggers on the sensor
inputs and will do so indefinitely. Some states have laws regulating how many
times a security system can trigger before it is considered a nuisance and the
vehicle is towed away.
2-3 Disarm from Valet, 1 pulse (1)
. Disarm from valet, 2-5 pulses (2). The system
can be programmed to count the number of presses of the valet switch before
disarming the security system. The factory default setting is one pulse. The unit
can also be set for two to five pulses.
2-4 Door trigger error chirp On (1):
Door trigger error chirp Off (2). This feature
controls the error chirp that is generated if the system is locked with the door
trigger active. This is useful in vehicles with a long dome light delay after the
door is closed. If the system is locked before the dome light turns Off, the system
generates the door trigger error chirp. If this error chirp notification is not desired,
use this feature to disable the door open error chirp notification. If the error chirp
notification is turned Off, no bypass chirp is generated, even if a door is ac-
cidentally left open.
2-5 Ignition Controlled Dome Light Supervision On (1):
If turned on, the system
turns on the dome light for 60 seconds when the ignition is turned off. The op-
47
© 2008 Directed Electronics. All rights reserved.