Clifford 50.7X Installation Manual page 17

H1/10 WHITE/BLUE
This input comes from the factory set to 1 activation pulse. This means that it is
necessary to have a single ground pulse on the white/blue wire for the remote
start to activate or to deactivate.
The H1/10 wire can also be used to activate the Turbo Timer mode when the
car is running and this wire receives a ground.
Note:
The number of activation inputs can be programmed to 1 or 2 pulses with
an optional momentary switch. This setting affects both the input wire and the
remote control when operating the remote starter.
H1/11
WHITE
This wire should be connected to the parking light wire in the vehicle. See Set-
ting the light flash polarity section of this guide for polarity settings.
© 2008 Directed Electronics. All rights reserved.
(-) REMOTE START/ TURBO TIMER ACTIVATION INPUT
To white/blue activation
input on system
PARKING LIGHT OUTPUT
17