Scosche DO2110 Installation

IN-DASH INSTALLATION KIT FOR
1999-UP DAEWOO LANOS/LEGANZA/NUBIRA
NOTES: • All wire codes are viewed as looking at the front of the plug with the wires exiting the rear.
• Use these wiring codes as a guide. Your vehicle might differ.
1999-UP DAEWOO VEHICLES
(Use Scosche DO01 for Car Stereo Connector)
Power and Speaker:
1 = Right Front Positive
2 = Right Rear Positive
3 = Illumination
4 = 12V Ignition/Switched
5= 12V Battery/Constant
6= Empty
7= Left Rear Positive
8= Left Front Positive
9= Right Front Negative
NOTE: • The following connectors are available to easily plug your new stereo cassette/disc player into
the factory harness
.
PART #: DESCRIPTION:
DO01 1999-UP Daewoo car stereo connector
DO2110
DO2110
KIT PANEL
DO2110
TRIM RING
WIRE CODES
10 = Right Rear Negative
11 = Empty
12 = Power Antenna
13 = Empty
14 = Chassis Ground
15 = Empty
16 = Empty
17 = Left Rear Negative
18 = Left Front Negative
This premium installation kit is for 1999-up Daewoo Lanos/Leganza and Nubira vehicles. Included are all of
the parts you need to mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the
individual instruction in this manual to remove your vehicle's factory radio and assemble the kit.
CAUTION: Disconnect your vehicle's negative battery terminal before the installation to help
prevent electrical damage. We recommend the use of a volt/ohm meter over a test light to check
wiring. A test light or grounded wire probe can cause damage to the vehicle's computer and/or
diagnostic systems. Avoid all factory air bag wiring - air bags can accidentally deploy causing
serious injury or death.
NOTES:
• See your vehicle's instructions for any special tools your installation requires.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
DIN RADIO INSTALLATION (DETACHABLE FACE/PULLOUT)
Slide the mounting sleeve (metal shroud) into the panel's radio opening and bend all available mounting tabs
DO2110
outward (see inset). Once the radio mounting sleeve has been fastened to the kit panel, slide the radio into
2 CD
POCKET the mounting sleeve until it locks into place.
NOTE: The mounting sleeve must be removed from the radio first!
Your radio may be snapped into its sleeve. Slide the mounting
sleeve (metal shroud) off the radio towards the back.
INTRODUCTION
KIT INSTALLATION
CAUTION:
REAR SUPPORTING THE
RADIO ADDS TO THE
INSTALLATION'S
STRUCTURAL INTEGRITY.
RADIO
MOUNTING
SLEEVE
DIN
RADIO
DO2110
TRIM RING
VARIOUS
REAR
SUPPORT
STRAPS
2 CD
POCKET
DO2110
MOUNTING
PANEL
BEND
TABS
OUTWARD