Connecting To A Home Wi-Fi Router - Lennox iComfort Wi-Fi® Thermostat Owner's Manual

Dehumidification Controls (Non-Communicating Outdoor Unit): Touch
the humidifier setting button you want to adjust. If it says de-humidifier OFF,
one touch will display a selection for OFF, MEDIUM and HIGH. Select
MEDIUM or HIGH to bring on the set-to button. When you touch the set-to
button, the arrows appear, allowing you to change to the desired humidity
setting.
Three climate settings are available for non-communicating equipment:
• OFF ­ The system supplies higher indoor airflow at all compressor
capacities. This will increase efficiency by operating at a higher
sensible-to-total ratio.
• MEDIUM ­ The system controls indoor airflow to ensure balanced
efficiency and comfort.
• HIGH ­ The system lowers the indoor airflow at all compressor
capacities. This setting improves humidity removal by operating at a
lower sensible-to total-ratio.
Remember that the humidification controls are only active while the system
is in the heating mode. The dehumidification controls are only active while in
the cooling mode.
SYSTEM SETTINGS
humidification
settings
%
heating
40
humidifier
mode
is ON
COMFORT
set to
ALL CHANGES MADE ON
THIS SCREEN ARE IN­
STANTLY SAVED.
Wi-Fi
9:39 am May 23, 2012
Figure 34. Humidifier Controls (Non-Communicating Outdoor Unit)
507342-01
dehumidification
settings
OFF
de- %
50
MEDIUM
humidifier
MEDIUM
set to
HIGH
(default is ON)
current indoor humidity is 50%

Connecting to a Home Wi-Fi Router

Check the router utility program or contact service provider for help.
The Wi-Fi thermostat must be close enough to the Wi-Fi router to ensure a
good communications signal between the thermostat and the router. (Hint:
use a smart phone with Wi-Fi and Wi-Fi finder application to locate and
determine signal strength.)
NOTE - The thermostat will not be able to reliably connect to the router
if the received signal strength indicator (RSSI) shows a larger negative
number than ­70 i.e. ­75, etc.
Secure Connection Recommended!
compatible with and set to operate in either 802.11b, 802.11g or 802.11n
wireless network modes. Check router utility program or contact
service provider for assistance.
Below are some possible conditions that will cause wireless interference
with the thermostat resulting in poor signal reception.
• Portable phones and bases
• Baby monitors
• Wireless speakers
humidifier
display
• Bluetooth devices
is ON
• Garage door openers
• Neighbors' wireless devices.
To eliminate a possible source of interference, temporarily disable any
devices and see if Wi-Fi performance has improved.
?
ENABLING WI-FI
To enable the Wi-Fi feature to communicate with a wireless router
Page 20
Verify that the router is