1. Put the tire on the ground at the rear of the vehicle
with the valve stem pointed upward.
3. Attach the wheel wrench (H) and
extensions (I) together.
2. Tilt the retainer (D)
downward and
through the wheel
opening. Make
sure the retainer is
fully seated across
the underside of
the wheel.
5. Raise the tire part way upward. Make sure the
retainer is seated in the wheel opening.
6. Raise the tire fully against the underside of the
vehicle. Continue turning the wheel wrench until the
tire is secure and the cable is tight. The spare tire
hoist cannot be overtightened.
4. Insert the hoist end (F)
through the hole (G) in
the rear bumper and into
the hoist shaft.
5-33