Using The Thermometer - WayFinder V2000 Operation Manual

Let the compass guide you
You can enter a course direction (bear-
ing point) and a guiding arrow will
appear on the compass rose. (Until a
bearing is stored, 00° displays in the
lower right corner.)
To enter a bearing point:
1. Align your vehicle so that the
desired numeric heading appears.
2. Hold
The message "PRESS AGAIN TO
STORE" cycles in the lower right
corner.
3. Press
The stored bearing point appears
in the lower right corner, and a
flashing arrow points toward that
direction on the compass rose. This
bearing point remains in memory
until you enter a new bearing point
or the battery is replaced.
4. Press
Turns display of stored bearing
point on or off.

Using the thermometer

Press to turn the temperature
display on or off. (If the temperature
sensor has not been properly installed,
"PLUG IN THE SENSOR" will
appear on the screen.) The Wayfinder
V2000 displays temperatures between
1°F and 158°F (-17°C to 70°C), or
will indicate that the measured tem-
perature is above or below this range.
To select °C or °F:
1. Hold
The message "PRESS AGAIN TO
STEP HOLD TO SELECT" cycles
in the lower right corner.
2. Press
Either °C or °F flashes in the lower
right corner.
3. Press
To toggle between °C and °F
4. Hold
Until "DONE" displays, saving
your selection in memory.
6