Channel Level Setup; Adjusting The Current Channel Level; Memorizing The Adjusted Channel Levels; Select The Channel Level - Denon AVR-390 Owner's Manual

ENGLISH

Channel Level Setup

Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote
control unit
Button only on the main unit
Button only on the remote control unit
o p ui
MEMORY/ENTER
d
uio p
[CH SELECT]
f

For details on how to select, set and cancel settings for each menu, see "Menu Operations" (vpage 15).
Adjust channel levels to obtain equal volume from all speakers.
[Display]
BUTTON
<BUTTON>
[BUTTON]
NOTE
Speaker set to "N" in the "Speaker Configuration" settings are not
displayed.
Adjusting the Current Channel
Level
You can adjust the current channel levels as desired. These
adjusted levels are just memorized into user's memory
("REFERENCE 1").
After adjusting each channel level with test tone, adjust the
channel levels either according to the program sources or to suit
your tastes. (For details, refer to "Adjusting Each Channel Level
with Test Tone" on page 28.)
MEMORY/ENTER
ui
q Press
The speaker that can be set switches each time one of the
buttons is pressed.
FL C
to select the desired channel.
FR SR SL SW DD
MODE:REF1
w P ress o p to adjust the level of the selected channel or program
source's LFE as desired.
[Variable range]
–15dB ~ 0dB
Other level :
–10dB ~ 0dB
LFE level :
b In general, we recommend the LFE level to be adjusted to 0
dB. (However, the recommended LFE level for some early DTS
software is −10 dB.) If the recommended levels seem too high,
lower setting as necessary.
e Repeat the above steps 1 and 2 to adjust each channel level.
Memorizing the Adjusted Channel
Levels
You can memorize the adjusted channel levels into preset memory
("REFERENCE 1", "REFERENCE 2") and recall the memorized
whenever you want.
q  A fter performing the steps 1 ~ 3 in "Adjusting the Current Channel
Level" procedure on page 18, press
The "1" of "REFERENCE 1" indication flashes.
w P ress o p to select the desired preset memory, then press
MEMORY/ENTER
.
b Each time o p is pressed, "REFERENCE 1" or "REFERENCE 2"
is selected.
b The adjusted channel levels have now been memorized into the
selected memory.

Select the Channel Level

DTS
This selects the memorized channel level.
[CH SELECT]
.
q Press
w P ress o p to select the mode ("REFERENCE 1" or "REFERENCE
2").
e After selecting the mode, press
The display returns to normal.
~ +15dB
MEMORY/ENTER
.
[CH SELECT]
once again.