Special Features; Program Location - Commando -PRO Operating Instructions Manual

SPECIAL FEATURES

1- CODE TEACHING
Turn the ignition key 3 times on/off, on/off, on, the siren will chirp.
Leave the ignition key in on position, press the valet switch for 5 seconds until the siren
chirps 3 times, Then press button # 1 on the remote transmitter. The siren will chirp once,
if you want to teach another transmitter with different code press # 1 on the second
transmitter the siren will chirp once. You can teach up to 3 different codes. After 10
seconds the LED starts flashing, now the alarm has learned the code of the transmitters.
2- WARN-AWAY
When using the dual zone shock sensor, the valet wire provides a Warn-Away Input.
When the alarm is armed, the first zone will chirp the siren 5 times and flash the parking lights
once, and the second zone will trigger the alarm.
3- VALET MODE:
To get into Valet mode, Disarm the alarm, turn the Ignition ON, hold the push button switch for
5 seconds until the LED comes ON solid. The system will be in VALET. Only the door lock/unlock
system will work on Valet (Keyless Entry).
To get out of Valet mode, turn the ignition ON and hold the switch down for 5 seconds, the
alarm will chirp and the LED goes out.
In an Emergency, When the alarm system has been triggered and the transmitters do not
respond to turn the alarm off. Get into the car turn the Ignition ON, hold the switch button down
for 5 seconds, the alarm will shut off and the LED will be on solid, this will override the system
and it will be in Valet Mode.
4- SHOCK SENSOR DISABLE FEATURE:
To disable the SHOCK SENSOR after arming the system. Press the 1st button once,
immediately after within 3 seconds press the 2nd button and the alarm will chirp one more time,
that will eliminate all trigger wires.
5-AUTO REARM:
When the alarm has been disarmed with the transmitter by mistake. It will automatically
rearmed itself within 30 seconds, unless you open one of the doors. This feature will
be always active no matter if the alarm is in active or passive mode.
6A-ANTI - CAR JACKING W/ DOOR
To activate the Car Jacking feature, Ignition should be (ON) If Door is opened 90 seconds
later the siren will chirp for 10 seconds to remind you that the system will be in car jacking
mode. After the reminder, the parking lights will flash & the siren will sound for 5 minutes,
and the (-) Gray wire (Starter kill) will be activated.
To turn the car jacking mode OFF, Ignition should be (ON) and press VALET
switch to reset the system.
6B-ANTI - CAR JACKING W/ REMOTE
To activate the Car Jacking feature, Ignition should be (ON) If The Remote Baton # 4 is
Preset 90 seconds later the siren will chirp for 10 seconds to remind you that the system
will be in car jacking mode. After the reminder, the parking lights will flash & the siren will
sound for 5 minutes, and the (-) Gray wire (Starter kill) will be activated.
To turn the car jacking mode OFF, Ignition should be (ON) and press REMOTER
BATON # 4 to reset the system.
3

PROGRAM LOCATION

PROGRAM LOCATION
PASSIVE
ON =
#1
ACTIVE
OFF=
DOSN'T DISARM ALARM WITH 2nd CHANNEL
ON =
#2
DISARM ALARM WTHE 2nd CHANNEL
OFF=
ON =
PARKING LIGHTS STAYS ON AFTER DISARM
#3
OFF=
PARKING LIGHTS FLASHES TWO TIMES
AUTO LOCK WITH IGNITION KEY
ON =
#4
OFF= NO LOCK WITH IGNITION KEY
ON = CHIRP ENABLED
#5
PERMENANT CHIRP DISABLE
OFF=
ON = AUTO ARMING (ACCIDENTAL DISARM)
#6
OFF=
NO AUTO ARMING
ON =
CAR JACK BY REMOTE
#7
OFF= CAR JACK BY DOOR
OPERATING THE REMOTE
Button #1
Hold 2 Sec. For 3rd Channel
LOCK / ARM
BUTTON #1
BUTTON #3
Hold 2 Sec. For TRUNK
PTX-4
Silend Arming & Disarming
8
UNLOCK / DISARM
BUTTON #2
*
BUTTON #4
PANIC
Car Jack w/Ign.ON