GMC 2011 Sierra Denali Owner's Manual page 430

10-86 Vehicle Care
10. Connect the other end of the
negative ( ) cable to the
remote negative ( ) terminal
on the vehicle with the dead
battery.
11. Start the vehicle with the good
battery and run the engine for a
while.
12. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Notice: If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct
order, making sure that the
cables do not touch each other
or other metal.
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine
Part or Remote Negative ( )
Terminal
B. Good Battery or Remote
Positive (+) and Remote
Negative ( ) Terminals
C. Dead Battery or Remote
Positive (+) Terminal
To disconnect the jumper cables
from both vehicles:
1. Disconnect the black
negative ( ) cable from the
vehicle that had the bad battery.
2. Disconnect the black
negative ( ) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+)
cable from the vehicle with the
good battery.
4. Disconnect the red positive (+)
cable from the other vehicle.
5. Return the remote positive (+)
terminal cover, if the vehicle has
one, to its original position.