Installation; Installation Location; Network Settings - D-Link EBR-2310 User Manual

Section 2 - Installation
The EBR-2310 can be positioned at any convenient place in your office or house. No special wiring or cooling requirements
are needed. However, you should comply with the following guidelines:
• Place the EBR-2310 on a flat horizontal plane.
• Keep away from any heating devices.
• Do not place in a dusty or wet environment.
The recommended operational specifications of the EBR-2310 are:
Temperature 32 F ~ 131°F
°
Humidity 5 % ~ 90 %
In addition, remember to turn off the power, remove the power cord from the outlet, and keep your hands dry when
you install the hardware.
To use the EBR-2310 correctly, you have to properly configure the network settings of your computers.The default IP address
of the EBR-2310 is 192.168.0.1, and the default subnet mask is 255.255.255.0. These addresses can be changed as needed,
but the default values are used in this manual. If the TCP/IP environment of your computer has not yet been configured, you
can refer to Configuring Your PCs to Connect to the EBR-2310 to configure it.
For example:
1. Configure your computer IP as 192.168.0.3, subnet mask as 255.255.255.0 and gateway as 192.168.0.1
Or more conveniently
2. Configure your computers to obtain TCP/IP settings automatically from the DHCP server feature of the
EBR-2310 Since the IP address of the EBR-2310 is 192.168.0.1, the IP address of your computer must
be 192.168.0.X (where "X" is a number between 2 and 254.) Each computer on your network must have
a different IP address within that range. The default gateway must be 192.168.0.1 (the IP address of the
EBR-2310).
D-Link EBR-2310 User Manual

Installation

Installation Location

Network Settings

11