Connecting Through A Private Network; Changing The Default Operating Mode - HP StorageWorks 4400 User Manual

Connecting through a private network

Use this procedure when the management module will not be connected through a public network or
the array has not yet been initialized
1.
Press and hold the recessed Reset button for 4–5 seconds (2
IP address of 192.168.0.1. The amber indicator on the top right corner of the Ethernet jack (1,
management
2. Browse to https://192.168.0.1:2373 and log in as an administrator. The user name is admin.
No password is required. The WOCP GUI appears.
3. If network setting changes are required, select Administrator Options > Configure Network Options.
4. Enter an IP address and other network settings that apply. Click Save Changes. The IP address
changes immediately, causing you to lose connectivity to the WOCP. You cannot save changes
if the EVA4400 storage system has not been initialized.
The new IP address is stored and remains in effect, even when the storage system is shut down
or restarted. However, the IP address will be lost if the storage system is uninitialized and the
WOCP reset.
5. From a computer on the private network, browse to https://newly configured ip address:2373
and log in as an administrator. The user name is admin. No password is required. The WOCP
GUI appears.

Changing the default operating mode

By default, the EVA4400 is shipped to operate in a Fibre Channel switch environment and is configured
in fabric mode. If you choose to connect the EVA4400 directly to a server, you must change the
default operating mode of the EVA4400 to direct mode. If you do not change this mode, the EVA4400
will be unable to communicate with your server. Use the web-based operator control panel (WOCP)
to change the default operating mode.
NOTE:
You must have administrator privilege to change the settings in the WOCP. Change your browser
settings for the WOCP window as described in the HP StorageWorks Command View EVA installation
guide .
To change the default operating mode:
1. Connect to the management module using one of the methods described in
a public network
2.
Log into the WOCP as an administrator. The default username is admin and the password field
is blank. For security reasons, change the password after you log in.
3. Select Administrator Options > Configure controller host ports.
The WOCP screen appears.
module) will flash momentarily when the reset operation is completed.
or Connecting through a private
HP StorageWorks 4400 Enterprise Virtual Array user guide
management
network.
module). This sets an
Connecting through
43