Connecting To The Network - HP StoreEasy 3830 Quick Start Manual

Figure 1 Interconnect bay numbering and device
mapping (c7000 enclosure)
Blade signal Interconnect bay
NIC 1 (embedded) 1
NIC 2 (embedded) 2
Mezzanine 1 3 and 4
Mezzanine 2 5 and 6
7 and 8
Interconnect bay
label
Page 3
Figure 2 Interconnect bay numbering and device
mapping (c3000 enclosure)
Blade signal Interconnect
bay
NICs 1 and 2 1
(embedded)
Mezzanine 1 2
Mezzanine 2 3, 4
For detailed port mapping information, see the HP
BladeSystem enclosure installation poster or the HP
BladeSystem enclosure setup and installation guide
on the following HP website:
http://www.hp.com/go/bladesystem/documentation

Connecting to the network

To connect the HP BladeSystem to a network, each
enclosure must be configured with network interconnect
devices to manage signals between the blades and
the external network.
Two types of interconnect modules are available for
HP BladeSystem c-Class enclosures:
Pass-thru modules
Switch modules
For more information about interconnect module
options, see the following HP website:
Interconnect Notes
bay label
Four port
cards connect
to bay 2
Four port
cards
Ports 1 and
3 connect
to bay 3
Ports 2 and
4 connect
to bay 4