Panasonic DMR-EH80V Operating Instructions Manual page 60

TIMER-controlled recordings
ShowView
8 3 5 4 2 - - - -
ENTER
:enter : access
0 - 9
: correct RETURN : return
Timer recording
Name Date Start Stop
1 ARD 19.11. 10:30 11:30 SP ON
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
- - - - - - - - -. - - - - :- - - - :- -
: select ENTER : access
CANCEL : delete RETURN
60
ShowView
Insert a video cassette with intact write-protection tab.
Press ShowView.
Enter the ShowView number using the number buttons.
Use
Confirm the ShowView number with ENTER.
In the Timer recording screen, check the start and end time and the VPS/PDC signal.
If [- - -] is displayed under Name, use
Use
1 / 3
Save the programme using ENTER.
VPS
Press
PDC
The
- - - -
- - - -
- - - -
- - - -
Automatic SP/LP switching
- - - -
A: If the remaining tape time is not sufficient to start a programmed recording,
then the SP/LP function switches to the LP tape speed. This ensures that the
: return
entire programme is recorded. If the remaining time on the tape is also not
enough in LP mode, then the programme cannot be recorded in full.
An automatic switching to EP mode is not possible.
VPS/PDC function
If the television station sends VPS/PDC signals, the beginning and end of a
recording are synchronised with the current air time.
The programme start time must be set correctly to the start time given in the
magazine.
When recording in the NTSC system, the function may not work.
Programming recordings with ShowView
to delete a number.
, to select the recording mode [A, SP, LP, EP].
TIMER to switch the unit to timer standby mode.
symbol lights up in the unit display.
.
to select the desired programme position.