Panasonic DMR-EH80V Operating Instructions Manual page 54

TIMER-controlled recordings
TIMER Remain HDD 72:50 LP DVD
RECORDING
VPS
Stop
Nr Name Datum No. Name Date Start Start Stop Mode Drive Mode
PDC
01 ARD MON - SAT 8:00 8:30
15:00
02 ZDF 18. 2. THU 15:30
03 NDR 18. 2. THU 10:30 11:30
New Timer Programme
Remain HDD
TIMER
RECORDING
Name Date Start
ENTER
CANCEL
RETURN
1 ARD 18. 2. THU 7:50
Press ENTER to input a programme name.
ENTER
CANCEL
RETURN
Storage space on the disc
OK: There is enough storage space available on
the disc for the recording. If VPS/PDC is
switched on during the recording, then the
entire programme will probably not be
recorded.
(Date): For recordings that are made daily or
weekly, the display indicates whether there
is enough storage space on the disc.
!:
Is displayed if the disc is not in the unit, is
write-protected or does not have enough
storage space.
Relief: Backup recording
54
3:59 LP
12:09:37 18. 2. THU
Press PROG/CHECK. The TIMER RECORDING screen appears.
VPS Disc
space Confirm the highlighted line with ENTER.
PDC
10/ 2
SP ON
Use
ON OK
SP
ON Relief
SP
If [
Use
72:50 LP DVD 3:59 LP [Name], [Date], [Start], [Stop], [Drive], [Mode], [VPS/PDC], [RENEW]
12:09:37 18. 2. THU
Name, Date, Start and Stop can also be entered using the numeric buttons.
VPS
Stop Drive Mode
If you want to enter the programme name, use
PDC
8:50 HDD SP On
and confirm with ENTER.
Once you have made all changes, save the programme with ENTER.
Programme Name
To continue programming, select [New Timer Programme].
Press
The
To cancel or pause the recording, press
HDD
programmes are not recorded on the HDD or disc,
-R
Backup recording
If there is not enough storage space available on the inserted disc at the start of the
TIMER-programmed recordings to DVD, the unit automatically saves the recording to
HDD (not with VPS/PDC programmed programmes that are overrun).
If a TIMER-programmed recording to DVD starts while the DUBBING function is active,
the unit automatically saves the recording to HDD.
VPS/PDC function
If the television station sends VPS/PDC signals, the beginning and end of a recording
are synchronised with the current air time. The programme start time
must be set correctly to the start time given in the magazine.
Manual programming
to select the name of the TV station.
] is displayed under Name, use
to select the option. Use
TIMER to switch the unit to timer standby mode.
symbol lights up in the unit display.
RAM
If you record several programmes in a row, the first few seconds of the following
-RW V +R approx. 30 seconds.
( )
to select the desired programme position.
to change the option.
to select [Programme Name]
TIMER again.
55
66