Disassembly - Pioneer DV-PT100-S Service Manual

1

7.5 DISASSEMBLY

1. REMOVAL OF MECHANICAL PARTS AND P.C. BOARDS
1-1: TOP CABINET, FRONT CABINET AND
A
OPERATION PCB ASSY (Refer to Fig. 1-1)
1. Remove the 5 screws 1.
2. Remove the Top Cabinet in the direction of arrow (A).
3. Disconnect the following connector: (CP651).
4. Unlock the 8 supports 2.
5. Remove the Front Cabinet in the direction of arrow (B).
6. Remove the 2 screws 3.
7. Remove the OPERATION PCB Assy in the direction of
arrow (C).
B
Top Cabinet
1
Front Cabinet
(B)
2
2
C
2
2
2
2
2
1-2: FLAP (Refer to Fig. 1-2)
1. Open Flap to 90° and flex in direction of arrow (A), at
the same time slide in direction of arrow (B).
D
2. Then lift in direction of arrow (C).
(C)
E
F
90
1
2
1
1
(A)
1
3
3
(C)
OPERATION PCB Assy
2
Fig. 1-1
(A)
(B)
Flap
Fig. 1-2
2
3
1-3: DVD DECK/DVD PCB ASSY
(Refer to Fig. 1-3)
1. Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
2. Unlock the support 1 and remove the Deck Top Holder
in the direction of arrow (A).
3. Remove the 2 screws 2.
4. Remove the 2 screws 3.
5. Disconnect the following connectors:
(CP501, CP8001).
6. Remove the DVD Deck in the direction of arrow (B).
7. Remove the 2 screws 4.
8. Remove the DVD PCB Assy in the direction of arrow
(C).
9. Remove the 3 screws 5.
1
10. Remove the Front Angle in the direction of arrow (D).
DVD Deck
Deck Top Holder
5
5
5
Front Angle
NOTE:
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and VCR PCB connector.
DV-PT100-S
3
4
4
4
DVD PCB Asy
Pickup PCB
3
2 (C)
1
3
(A)
2
(B)
Make the short circuit
using a soldering.
(D)
4
Fig. 1-3