Unpacking Precautions; Horizontal And Vertical Image Shift - ICP Electronics LCD-Kit01 User Manual

2.3 Unpacking Precautions

Some components on LCD-Kit01 are very sensitive to static electric
charges and can be damaged by a sudden rush of power. Ground
yourself to remove any static charge before touching your LCD-
Kit01 . You can do it by using a grounded wrist strap at all times or
by frequently touching any conducting materials that is connected to
the ground.
Do not touch the inner side of LCD module and the connector/cable
of fluorescent lamp/backlight when the power is on. The inverter
supplies HIGH VOLTAGE to these parts (~ 300Vrms).
Disconnect power supply before handling and doing connection on
LCD-Kit01. Do not plug any connector or jumper while the power is
on. It will cause fatal damage to your LCD panel.
Make sure that every connector is connected in correct direction.
Any incorrect connection may cause smoke or burn of electrical
parts or fatal damage of your LCD panel.
Be careful with the liquid crystal material. Do not swallow, inhale or
have skin contact with this material in case that the LCD panel is
broken and the liquid flow out. If you inhale the liquid material, rinse
your mouth immediately with water then go to see a doctor. If you
have skin contact with the liquid, wash it immediately with alcohol.
Be careful, too, with the chips of glass if the panel is broken.
LCD-Kit01 640 x 480 / 18 bits
P64CV1

2.4 Horizontal and Vertical Image Shift

7
• JP1 : Horizontal Image Shift-direction Jumper
This setting also can be done by shorting J3 or J4
Disaster note: Do not short both J3 and J4
• JP2 : Vertical Image Shift-direction Jumper
This setting also can be done by shorting J5 or J6
Disaster note: Do not short both J5 and J6
LCD-Kit01 640 x 480 / 18 bits
P64CV1
default
setting
or J3 pad
short
or J3, J5 pads
short
or J5 pad short
8