Page 2
Copyright Notice This document and product is copyrighted, July 2000, by ICP Electronics Inc. All rights are reserved. No part of this manual may be reproduced, copied, or translated without prior notice to ICP Electronics Inc. The information provided in this document is for reference only. We do not assume any responsibility arising out of the application of the products.
Table of Contents Chapter 1 Product Information 1.1 Product Information and Specifications 1.2 Mechanical Dimensions Chapter 2 System Setup 2.1 Front Panel 2.2 Rear Panel 2.3 LCD Installation 2.4 Keyboard Installation 2.5 Touch-pad Installation 2.6 Rack Mounting 2.7 Power Supply Installation Appendix A Exploded Diagram Appendix B Display Interface Appendix C PCB Board Assembly Diagram...
Page 4
Chapter 1 Product Information 1.1 Product Specification and Information The LKM-926 is a 15" flat panel display specially designed to meet the applications for Industrial environment. Suitable for rack mounting. Panel Interface: 15 Pin D-Type connector for standard VGA Support PS2 Keyboard and PS2 Touch Pad (RS232 Touch Screen is option) Two speakers for stereo audio in.
Page 5
LCD: TOSHIBA LTM15C423S 15" high brightness TFT LCD Resolution: 1024x768 MAX. Colors: 36 bits Luminance: 250cd/m Operating Temperature: 0-50 LCD MTBF: 50,000 hrs Backlight MTBF: 30,000 hrs VGA to LCD Converter Board and OSD use method please refer to AV-6721 Manual.
Page 6
1.2 Dimensions The following diagrams indicate the dimensions of LKM-926. 7x10.5 OB Holes UNIT:mm...
Chapter 2 System Setup The LKM-926 is very easy to set up for operation. When you set up your system, please follow the below procedures. 2.1 Front Panel LKM-926 is a compact design with 15” TFT LCD Display, keyboard and touch-pad.
2.2 Rear Panel On the rear panel, LKM-926 provides 5 Channel VGA, PS/2 mouse, keyboard and Audio for your application. VGA Port PS/2 Mouse PS/2 Keyboard Audio DC+12V IN AC IN Power Supply Warning: Before any installation / un-installation, please notice...
To install the keyboard, please follow the below steps: 1. Connect the keyboard to LKM-926 control board first. 2. Fasten the keyboard carrier by four screws and then place the keyboard. 3. Fasten the keyboard cover to the housing of LKM-926.
2.5 Touch-pad Installation Install the touch-pad to the keyboard cover as the below figure shown and then assemble the cover to the housing of LKM-926.
2.6 Rack Mounting LKM-926 supply the rear bolster which can be utilized in Rack to provide the better conjugation. For Rack mount 2.7 Power Supply Installation...