Table of Contents
Advertisement
2.3 Unpacking Precautions
ü
Some components on LCD-Kit03 are very sensitive to static electric
charges and can be damaged by a sudden rush of power. Ground
yourself to remove any static charge before touching your LCD-
Kit03 . You can do it by using a grounded wrist strap at all times or
by frequently touching any conducting materials that is connected
to the ground.
ü
Do not touch the inner side of LCD panel and the connector/cable of
fluorescent lamp/backlight when the power is on. The inverter
supplies HIGH VOLTAGE to these parts (~ 550Vrms).
ü
Disconnect power supply before handling and doing connection on
LCD-Kit03. Do not plug any connector or jumper while the power is
on. It will cause fatal damage to your LCD panel.
ü
Make sure that every connector is connected in correct direction.
Any incorrect connection may cause smoke or burn of electrical
parts or fatal damage of your LCD panel.
ü
Be careful with the liquid crystal material. Do not swallow, inhale or
have skin contact with this material in case that the LCD panel is
broken and the liquid flow out. If you inhale the liquid material, rinse
your mouth immediately with water then go to see a doctor. If you
have skin contact with the liquid, wash it immediately with alcohol.
Be careful, too, with the chips of glass if the panel is broken.
ü
For outdoor usage, an ultra-violet ray protect-lens is recommended
to apply onto LCD display. It will prevent your LCD from strong sun-
light, scratches, dust and water invasion etc. which can cause
damage to the LCD display.
LCD-Kit03 640 x 480 / 18 bits
LTM10C209A
7
Advertisement
Table of Contents
