Bios Setting For Sbcs With Hm86508 Chipset; Appendix A. P64Cv1 Display - Switch Setting - ICP Electronics LCD-Kit01 User Manual

4.2 BIOS Setting for SBCs with HM86508 Chipset

LCD-Kit01
BIOS Setup
JUKI-730 use flash634 j730lcd1.rom to upgrade bios
(ALi6117)
JUKI-732E use flash634 j732lcd1.rom to upgrade bios
(ALi6117)
JUKI-750E use flash631 j750lcd1.rom to upgrade bios
(ACC Maple)
JUKI-752 use flash631 j752lcd1.rom to upgrade bios
(ACC Maple)
PM-1021 use flash634 1021lcd1.rom to upgrade bios
(ALi6117)
NOVA-300 use flash634 n300lcd1.rom to upgrade bios
(ALi6117)
WAFER-4823 use flash631 4823lcd1.rom to upgrade bios
(ACC Maple)
Note : to upgrade the BIOS, under DOS prompt insert the
attached disk then type the bold letter command of the middle
column then follow the instruction on your monitor.
Example: for NOVA-300 SBC, under DOS prompt type:
A:\ flash634 n300lcd1.rom or
C:\ flash634 n300lcd1.rom if you have copied the files
flash634.com and n300lcd1.rom to your hard-disk.
LCD-Kit01 640 x 480 / 18 bits
P64CV1
LCD Volt. Setting
No volt. Setting
(5V only)
No volt. Setting
(5V only)
No volt. Setting
(5V only)
No volt. Setting
(5V only)
No volt. Setting
(5V only)
No volt. Setting
(5V only)
No volt. Setting
(5V only)
17
Appendix A. P64CV1 Display – Switch Setting
There are two switches on the back of LCD01 Display. These
switches have been set to the factory-setting. Your LCD01 comes
in ready-to-use condition, don't change this setting unnecessary.
Notes: 1. HP6~HP0 is for picture level setting
2. U/D is for picture horizontal rotation
3. R/L is for picture vertical rotation
4. Don't change the 'system internal setting'
LCD-Kit01 640 x 480 / 18 bits
P64CV1
18