Wireless Programming - Chamberlain ML750 Installation And Operating Instructions Manual

25

WIRELESS PROGRAMMING

Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage while door is in motion. Do not allow children to operate push button(s)
or remote(s). Do not allow children to play near the door.
The remote controls supplied with your opener are pre-programmed to your receiver in the factory.
If you purchase additional remote controls, you will need to program them into your opener using the steps
below.
Adding remotes:
Using the orange "LEARN" button:
1. Press and hold the button on the hand held remote you wish to program to the opener. The learn LED will
flash continuously.
2. Press and release the orange "learn" button.
3. Release the button on the hand held remote when the opener light flashes. It has learned the code. If the
light bulb is not installed, one click will be heard.
Using the multi-function door control:
1. Press and hold the button on the hand-held remote that you wish to operate your garage door.
2. While holding the remote button, press and hold the LIGHT button on the multi-function door control.
3. Continue holding both buttons while you press the push bar on the multi-function door control (all three
buttons are held).
4. Release buttons when the opener light flashes. It has learned the code. If the light bulb is not installed,
one click will be heard.
Deleting ALL remote control codes
NOTE: This deletes all remotes and codes
Press and hold the orange "learn" button on opener until the learn indicator light goes out (approximately 6
seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.
1
2
3
4
11
1
2
3