Using An Effect; Routing Audio Through An Effect - Yamaha 01V96i Quick Start Manual

✦

USING AN EFFECT

Before an effect can be used properly, it needs to be
patched. The default patch (factory setting) has Aux 1-4
patched to the inputs of FX1-4 respectively. The stereo out-
puts of FX1-4 are patched to stereo input channels 1-4
respectively. This is convenient, but can be changed if nec-
essary. For example, an effect could be inserted in just one
channel using the INSERT OUT and IN patch. To change
the FX patching, go to the EFFECT page in the [PATCH]
display menu.
✦

ROUTING AUDIO THROUGH AN EFFECT

1.
First, audio needs to be routed into the effect. If the default patch is used, first turn up Aux 1 send level for the
required channel: Select Aux1 fader mode, and push up the fader to the required level.
2.
Check that the Aux 1 Master fader is up to 0dB (that is its default position): select Master Layer and adjust the
Aux1 fader position if necessary.
3.
Already audio should be seen on the level meters of Effect 1. You can see the meters on the top-right corner of
the FX EDIT screen.
4.
Then turn up ST IN 1 to start hearing the effect's output in the Stereo bus: select the top layer for the ST IN
channels, and turn up ST IN1 encoder. The level can be viewed in the top-right corner of the LCD.
1
3
2
18/32
01V96i Quick Start Guide
4