Ntsc, Pal, Secam; Ledview-510/530 System Description - Calibre LEDView-510 Operating Instructions Manual

2.1. Product Overview
LEDView-510/530 is designed to accept the following input signals:
 Composite video via BNC
 Composite video via RCA
 S-Video via 4-way miniDIN
 YPbPr or RGBS SD/ED/HD component video via 3/4xBNC
 3G-SDI/HD-SDI/SDI (Serial Digital Interface) via BNC
 VGA analog (computer interface) via 15HDD
 DVI (Digital Visual Interface) via DVI-I (supporting a digital and 2
 HDMI via HDMI connector
2.2. Product Specification
This section provides technical details for all possible inputs. Please note that not all possible input
options may be applicable to certain output modes.
2.2.1. Power Supply Requirement
100V-264VAC 50/60Hz connected via a standard IEC connector located on the rear panel.
2.2.2. Video Inputs
Composite via BNC and RCA connector, S-Video via 4-way mini DIN socket
Signal formats
Standards
Composite (CVBS) input level
Luminance (Y) input level
Chrominance (C) input level
Input Impedance (all inputs)
2.2.3. Component Video Inputs
Via 3 or 4 BNC connectors
YPbPr, YPbPrS, RGB and RGBS component video, menu selectable.
Signal formats 484i (480i) and 576i (SD), 480p, 576p (ED), 720p, 1080i at 50, 59.94 and 60Hz and
1080p at 23.98, 24, 25, 29.97 and 30Hz.
Please note this input does not support Computer SVGA signals which should be connected via the
Computer SVGA input
2.2.4. 3G-SDI Input
Format:
Input impedance:
SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant, accepts 484i, 576i, 720, 1080i and
1080p single link formats at 270Mb, 1.485Gb or 2.97Gb rates.
©
Calibre UK Limited Issue 2.00
T:+44 1274 394125 F: +44 1274 730960 E:

LEDVIEW-510/530 SYSTEM DESCRIPTION

Composite (CVBS), S-Video (Y/C)

NTSC, PAL, SECAM

1V p-p nominal incl. sync
1V p-p nominal incl. sync
0.6V p-p nominal
75 Ohms
SD-SDI, HD-SDI and 3G-SDI YCbCr 4:2:2 serial digital component video
75 ohms.
30 March 2012, W: www.calibreuk.com
techsupport@calibreuk..com
nd
analogue VGA input)
4