Output Config - Calibre LEDView-510 Operating Instructions Manual

3.5.9.

Output Config

This Menu provides items to configure the output port.
Sync Mode
The VGA output port can be operated with separate syncs, composite syncs and Sync-On-Green.
Internally, the display interface processes data at a full ten bits per colour. A resolution of ten bits per
Optimize for Display
Settings: DVI forced, Optimized, DVI/HDMI
Internally, the display interface processes data at a full ten bits per colour. A resolution of ten bits per
colour is provided for the VGA output. The colour depth on the DVI-D output is determined by the
supported standard of the attached monitor or device when set to DVI/HDMI. For DVI 1.0 and HDMI
1.1/1.2 devices it is 24 bit, for HDMI 1.3 compliant devices it is up to 36 bit.
DVI forced will output with 24 bit colour depth irrespective of the supported standard of the attached
monitor.
When the Optimized setting is enabled the output resolution is automatically set to the native screen
resolution of the attached display. The colour depth is determined in the same way as when set to
DVI/HDMI.
DVI Colour Space and DVI Range
The colour space of the DVI output port can be set to RGB or YPbPr, the range can be set to Expand,
Normal, Compress and Auto. A limited video range is only using the following greyscale for video
information - 8 Bit System: 0x01 .. 0xFE, 10 Bit System: 0x004 .. 0x03FB.
Frame Rates
Settings: 60/50 Hz, 60/50/24 Hz, 60/50/48, 60/50/24/48
Limits the possible output frame rates for the Auto refresh rate configuration discussed in paragraph
3.5.3.
3G-SDI Data Map
720p and 1080i HD-SDI data can be output in YCbCr 4:2:2, YCbCr 4:4:4 or RGB 4:4:4 mode.
3GSDI data can be output as Level A or B data.
3.5.10. Output Window Size
In this submenu the size of the output window can be set, i.e. the image size is reduced and positioned
according to the right, left, top and bottom edge slider setting. The image can be reduced to as few as
128x96 pixels. A reset function is provided for convenience to set all sliders back to full output
resolution.
Note: When the Windows Size function is enabled the latency of the system increases by 1 frame.
©
Calibre UK Limited Issue 2.00
T:+44 1274 394125 F: +44 1274 730960 E:
30 March 2012, W: www.calibreuk.com
techsupport@calibreuk..com
20