Midi Setup Menu - Roland VR-3 Reference

MIDI Setup Menu

You can modify the MIDI remote control settings of the VR-3 from [MIDI] in [SYSTEM] menu.
* For menu operations and menu items, refer to [Menu Operations and Menu List] in the owner's manual.
COM : Setup Menu
Make settings common to the three MIDI modes.
COM : MIDI OUT
When set to OUT, the MIDI OUT jack will send messages generated by the VR-3. When set to THRU, all incoming MIDI messages
will be re-transmitted to the MIDI OUT jack.
COM : Tx CHANNEL
This sets the Tx channel for output of MIDI messages.
STD : Setup Menu
Set items here for standard mode.
STD : Rx CHANNEL
This sets the Rx channel of MIDI messages. If this is [OFF], the channel voice messages of standard mode will not be received.
STD : VIDEO SEL TYPE
This sets the method of video channel switching as below.
VLNK
With this method, you can switch using bank select (BS) and program change (PC). See below for channel selection.
PC 1
BS MSB:0 LSB:0 Video 1
BS MSB:1 LSB:0 Sub Video 1
* Sub Video is the channel for composition.
AR
With this method, you can switch using program change (PC) and note on. See below for channel selection.
PC Note No.
21 0-3
22 0-3
* Sub Video is the channel for composition.
4
PC 2 PC 3
Video 2 Video 3
Sub Video 2 Sub Video 3
Assign
Video 1-4
Sub Video 1-4
PC 4
Video 4
Sub Video 4