Intelliswitch; Quick Start Operation - Berner Maxair Installation & Maintenance Instructions Manual

that comes with a factory installed digital programmable controller called the Intelliswitch™
INTELLISWITCH™ QUICK START OPERATION
When power is turned on to the Air Door, all of the lights on the display will light briefly while the
Intelliswitch™ starts up. After startup the clock will then display. The Intelliswich is now ready to set.
To operate the air door:
Press the Down Arrow (Menu) button once.
NOTE: If the Down Arrow button is pressed
twice, the function will change from "Mode" to
"Fan Speed".
Using either the Left or Right Arrow buttons,
scroll through the Modes of Operation until you
reach the desired mode.
See below to determine which mode is right for you.
For detailed information of the Intelliswitch™ Navigation and Operation please refer to Appendix A (see pages 12-18)
Once the Mode of Operation is selected, press
"OK" button to set and return to the clock or the
down arrow to select and adjust any of the other
available settings.
Mode of Operation:
The unit will not run.
OFF
The unit will run continuously unless a
ON
start and stop time is programmed.
The following modes can be customized see "Programming the Intelliswitch" for more info.
For use with a door switch, the unit will operate
only when the door is open.
AUTO
For use with a door switch, the unit will operate
only when the door is open with a minimum 1
"delu"
minute delay before turning off when it closes.
DELUXE
How to operate your MaxAir & Zephyr Air Door
www.intelli-how2.com
NOTE: To adjust the clock, refer to section 4.5 Appendix A.
Mode/Fan Speed indicator will light
10
OFF
ON
AUTO
delu