Table of Contents
Advertisement
4
Press and hold the number button (in
this example, 1) for more than 2
seconds.
7
5
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
"P1" flashes for a few seconds.
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 10 and 11.
1
Select the tuner as the source.
TUNER
(FM1 – 3, AM)
• The last selected station is tuned in.
2
Select the band (FM1 – 3, AM) if
neccessary.
FM1
3
Select the number (1 – 6) for the preset
station you want.
7
8
Other convenient tuner functions
Scanning broadcast stations
SCAN
RPT
When you press SCAN RPT while listening to the
radio, station scanning starts. Each time a broadcast
is tuned in, scanning stops for about 5 seconds
(tuned frequency number flashes on the display),
and you can check what program is now being
broadcast.
If you want to listen to that program, press the same
button again to stop scanning.
Tuner
CD
FM2
FM3
AM
9
10
11
12
11
Advertisement
Table of Contents
