Installing The Batteries - C. Crane CCRadio2E Instruction Manual

Manual_ccradio2E_Linear-HQ-R2_1_ccrane 2/14/14 9:20 AM Page 7
Getting Started

INSTALLING THE BATTERIES

1) Position the radio face down on a soft surface to protect it.
2) Remove the battery compartment cover.
3) Insert the (4) "D" cell batteries into the compartment as indicated in
the drawing below. Be sure the negative (-) end is against the
spring. Refer to the drawing below to insure correct installation of
your batteries.
4) Replace the battery cover. You are now ready to operate your radio.
BATTERY REPLACEMENT
The battery indicator will display the battery level for one to two
seconds when the radio is switched off. After removing dead batteries
for replacement, you have approximately three minutes to replace the
batteries before your clock and memory information will be lost (if the
radio is not plugged in).
This symbol means
the batteries are full.
CCRadio 2E
Remove battery cover by pressing
both clips at the same time towards
the bottom of the radio.
First
Battery
Third
Battery
This symbol means
batteries are low.
AC power cord
plugs in here.
Second
Battery
Fourth
Battery
This flashing symbol means
the batteries need replacing.
Page 7