Step 3 Preparing The Remote Control; Step 4 Presetting The Radio Stations - Panasonic SC-PTX5 Setup Manual

3
step
Preparing the remote control
∫ Batteries
Insert so the poles (i and j) match those in the
remote control.
R6/LR6, AA
Replace the cover.
≥ Do not use rechargeable type batteries.
4
step
Presetting the radio stations
FM
Numbered
buttons
,
TUNING
Radio operations are described mainly with the remote
control.
You can alternatively use the corresponding button on
this unit.
[X TUNING W]
§1 §2
[SELECTOR]
Press in and lift up.
,
ENTER
MANUAL SKIP
SELECTOR MEMORY
-TUNE MODE
§3
[MEMORY]
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage
which can severely damage the remote control.
Remove the batteries if the remote control is not going to
be used for a long period of time. Store in a cool, dark
place.
∫ Use
Aim at the remote control signal sensor (➜ page 11,
Operations Guide), avoiding obstacles, at a maximum
range of 7 m directly in front of the unit.
Up to 30 stations can be set.
1 §1
Press [FM] to select "FM".
Press [6, 5]
2
≥ When performing this step on this unit, first press
[-TUNE MODE] to select "MANUAL", and then
press [X TUNING W] to select the frequency.
To start automatic tuning, press and hold
[6, 5] until the frequency starts scrolling. Tuning
stops when a station is found.
3
While listening to the broadcast
§3
Press [ENTER]
4
While the frequency and "PGM" are flashing on the
display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W], and
then press [ENTER]
Confirming the preset channels
1 §1
Press [FM] to select "FM".
2
Press the numbered buttons to select the
channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W].
≥ To perform this step on this
unit, first press [-TUNE MODE] to select
"PRESET", and then press [X TUNING W] to
select the channel.
5
§2
to select the frequency.
.
e.g. Display
DISC SFC TG
§3
.
e.g. Display
DISC SFC TG
D.MIX MONO SLP
D.MIX MONO SLP