Advertisement
Step 1
Install F-Connector on the Cisco CMC:
a. Unscrew the six ½-inch closure bolts on Cisco CMC lid using a torque wrench and open the lid.
b. Cisco CMC supports PG11 and 5/8" F-connectors. Trim the F-connector with a heavy-duty wire cutters to match the
F-connector strip on the Cisco CMC. To use PG11 F-connector, remove the PG11 to 5/8" adapter from the port with a
torque wrench.
c. Lightly loosen the seizure screw. Do not remove it. Install the F-connector into the RF port and tighten the connector
nut with a torque wrench and then tighten the seizure screw using a slot screwdriver.
d. Install a 5/8" port plug into each unused RF port.
e. Close the lid and lightly tighten the six ½-inch closure bolts.
Mount the Cisco CMC either on a wall or strand. The maximum weight of the Cisco CMC is 11.8 kg (26 lb).
Step 2
• Wall-Mounting
a. Drill four holes in the wall at a distance of 291 mm x 158.4 mm. Align the Cisco CMC horizontally with the holes on
the wall and ensure proper ventilation around it.
b. Insert an M8 or 5/16" expansion bolt into each hole.
2
Strip
CATV IN Port
32mm
35mm
PORT 1
Seizure Screw
291mm
PG11 Strip
5/8" Strip
F-Connector
158.4mm
Mounting Holes
Mounting Holes
Advertisement
