2-2.
For digital "A" type and "A" type lenses only
(A) Lens side preparation
Set the focus operation change-over
knob at the bottom of the lens drive
unit to "SERVO" position.
(NOTE) :
(B) Mount the necessary accessories
1. To mount the clamper
Loosen the large and small fastening
knobs of the clamper provided with the
fl exible zoom control unit.
Mount this unit onto panning rod of
the tripod, and tighten both fastening
knobs to secure the clamper.
2. To mount the focus demand
Mate the rose joint of the focus
demand with the rose joint of the
clamper.
Then tighten them with the mounting
k n o b o f t h e c l a m p e r b y t u r n i n g
clockwise.
For smooth change,
turn the change-over
knob while rotating
the focus ring slightly.
Mouning Knob
Mouning Knob
Clamper
- 29 -
Focus Operation Change-over
Knob
Clamper
Fastening Knobs
Focus Demand