Lnb Commands; System Communications Commands - Comtech EF Data KST-2000L Installation And Operation Manual

Satellite Terminal System
Terminal Mode Commands
7.5

LNB Commands

Commands and responses to control and to determine the status of an LNB.
LNB Command
Power Enable Response
Status
Response
LNB Command
Calibration Response
LNB Command
Fault Enable Response
Status
Response
Select Receive Command
Band Response
Status
Response
7.6

System Communications Commands

Commands and responses for setting up communications with the system.
Address Command
Select Response
Status
Response
Baud Rate Command
Select Response
Status
Response
Parity Command
Select Response
Status
Response
<add/LPE_xxx'cr' Where xxx = ON/OFF, default is OFF
>add/LPE_xxx'cr''lf']
<add/LPE_ 'cr'
>add/LPE_xxx'cr''lf']
<add/CLNAB_'cr' Calibration to allow system to determine nominal LNB power
>add/CLNAB_''cr''lf'] consumption, performed at initial installation only
<add/LFE_xxx'cr' Where xxx= ON/OFF, default is ON
>add/LFE_xxx'cr''lf'] Determines if the system takes action on LNA fault notification
<add/LFE_'cr'
>add/LFE_xxx'cr''lf']
<add/SRB_n'cr' Where n = A for 10.95 to 11.70 GHz
>add/SRB_n'cr''lf']
<add/SRB_'cr'
>add/SRB_n'cr''lf']
<add/AS_xxx'cr' Where add = present address and xxx = new address, 1 to 255
>add/AS_xxx'cr''lf'] (default = 1)
<add/AS_'cr'
>add/AS_xxx'cr''lf']
<add/BR_xxx'cr' Where xxx = 300, 600, 1200, 2400, 4800, 9600 or 19200 (default
>add/BR_xxx'cr''lf'] = 9600)
<add/BR_'cr'
>add/BR_xxx'cr''lf']
<add/PS_xxx'cr' Where xxx = OD (odd), EV (even) or NO (none – 8 bit), default =
>add/PS_xxx'cr''lf'] EV
<add/PS_'cr'
>add/PS_xxx'cr''lf']
7–6
B for 11.70 to 12.20 GHz
C for 12.25 to 12.75 GHz
Revision 2
MN/KST2000L.IOM